Kawasaki KRX Forum banner

1 - 20 of 36 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter #1 (Edited)
Has anyone put together a tool kit?
So far I have the following-
22mm wrench x2 (for shifter linkage adjustment)
10mm 3/8 socket (for changing belt and fits many other fasteners)
12mm 3/8 socket (for changing belt and fits many other fasteners)
3/8 socket ratchet with 2" and 6" extensions
M10x1.25x100 bolt for spreading clutch
Scotch pad for quick clutch clean when changing belt
Long needle nose pliers with wire cutters makes removing blown belt easy
17mm 3/8 socket for lug nuts and suspension components
14mm 3/8 socket for beadlock bolts and other stuff
3/8 breaker bar
Multi screwdriver
Spare belt

Any additions welcome
 

·
Registered
Joined
·
94 Posts
Tire patch kit
Tire irons
Small 12v air compressor
Battery jumper
17mm for lugs
Flat and Phillips screwdrivers
Spare electrical wire
Duct tape!!!
 

·
Registered
Joined
·
18 Posts
This is exactly what I was wondering. I would like to take the tools most needed just in case but didn't want to take so much that it all rolls around and is clunky. Just the tools that are most needed. I hope this thread gets updated.
 

·
Registered
Joined
·
18 Posts
I also think (for me at least) that it would be nice if you say what the tool would be used for like above Thumper said "17mm for lugs"
 

·
Registered
Joined
·
155 Posts
Discussion Starter #7
I also think (for me at least) that it would be nice if you say what the tool would be used for like above Thumper said "17mm for lugs"
Ok, I updated my post. Hope it helps. It's exactly what I carry.
 

·
Registered
Joined
·
18 Posts
What do you guys carry all your tools in? I am thinking some kind of tool roll so that it stays all together and takes up less space. I don't have one yet but just my thought.
 

·
Registered
Joined
·
24 Posts
I love this thread, I already have a full tool kit for my Wildcat 1000X 4 based upon experience, this allows me to start assembling another kit before I take the KRX South to Mesquite NV for the Winter riding season.
 

·
Registered
Joined
·
38 Posts
Suc
Has anyone put together a tool kit?
So far I have the following-
22mm wrench x2 (for shifter linkage adjustment)
10mm 3/8 socket (for changing belt and fits many other fasteners)
12mm 3/8 socket (for changing belt and fits many other fasteners)
3/8 socket ratchet with 2" and 6" extensions
M10x1.25x100 bolt for spreading clutch
Scotch pad for quick clutch clean when changing belt
Long needle nose pliers with wire cutters makes removing blown belt easy
17mm 3/8 socket for lug nuts and suspension components
14mm 3/8 socket for beadlock bolts and other stuff
3/8 breaker bar
Multi screwdriver
Spare belt

Any additions welcome
Anybody mention Duct Tape, and the fork little for them damn plastic rivets!
 
1 - 20 of 36 Posts
Top