Kawasaki KRX Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
389 Posts
Discussion Starter · #1 ·
So the boxes of goodies are arriving finally. Kawasaki sent me the headlight guard and no front bumper to attach it to!?!? I mean WTF? No email saying it wasn't in stock...just got an email AFTER it was delivered. I would have went super atv front bumper had that been the case.
 

Attachments

·
Registered
2021 KRX 1000 blue tons of options
Joined
·
590 Posts
So the boxes of goodies are arriving finally. Kawasaki sent me the headlight guard and no front bumper to attach it to!?!? I mean WTF? No email saying it wasn't in stock...just got an email AFTER it was delivered. I would have went super atv front bumper had that been the case.

Could you cancel it from Kawi? Rocky Mountain has it in stock. $161.99 free shipping and they ship fast. I find them to have cheaper prices than Kawasaki often.
 

·
Registered
Joined
·
389 Posts
Discussion Starter · #3 ·

Could you cancel it from Kawi? Rocky Mountain has it in stock. $161.99 free shipping and they ship fast.
They canceled it for me since it wasn't in stock. But thanks for the heads up...Going to their website now!
 

·
Registered
2021 KRX 1000 blue tons of options
Joined
·
590 Posts
They canceled it for me since it wasn't in stock. But thanks for the heads up...Going to their website now!
Also, if you make an account, rocky mountain does cash back rewards on lots of things. Not exactly cash but they give you a rewards dollar amount and it will build up value each time you buy. I bought so much stuff I got my rear bumper basically for free.
 

·
Super Moderator
2020 Green KRX
Joined
·
1,132 Posts
Also, if you make an account, rocky mountain does cash back rewards on lots of things. Not exactly cash but they give you a rewards dollar amount and it will build up value each time you buy. I bought so much stuff I got my rear bumper basically for free.
Thanks for this, I should of looked more before we ordered my rear bumper. Side by side sports . Com charges a ton for shipping.
 

·
Registered
2021 KRX 1000 blue tons of options
Joined
·
590 Posts
Once you spend $75 Rocky Mountain is free shipping. But being a KRX owner, we all know everything in $99 and up. Lol. I ordered 75% of my accessories from them. Even my fluids
 

·
Registered
Joined
·
389 Posts
Discussion Starter · #8 ·
Once you spend $75 Rocky Mountain is free shipping. But being a KRX owner, we all know everything in $99 and up. Lol. I ordered 75% of my accessories from them. Even my fluids

Yeah I see this now! I could have saved a couple hundred bucks ordering through them. Some stuff I ordered through amazon...I swear by mctuning switches and harnesses. But mostly everything else was kawasaki minus new 4 point harnesses and 4 nilights
 

·
Registered
Joined
·
389 Posts
Discussion Starter · #9 ·
@Atcdan13 what are you and everyone using for a power point/source of power? I haven't dug into yet or searched the site but I know you wired up a bunch of stuff.
 

·
Registered
2021 KRX 1000 blue tons of options
Joined
·
590 Posts
There is a bus bar behind the center dash panel that is already placed there from the factory and it’s hot when you turn the key on. I didn’t like how it was set up though so I took it off and put two separate bars back there for positive and ground that have I think 6 screws each. My speaker bar goes directly to the battery so I can use it when the machine is off. Other than the winch power wires though, everything else goes to the bus bar. Kawi made it super easy to hook things up. That center panel is only held in by like 6 pins and 2 screws. I had to pull the whole center tunnel out to run a few things as well. That requires a bit more work.
 

·
Registered
Joined
·
389 Posts
Discussion Starter · #12 ·
There is a bus bar behind the center dash panel that is already placed there from the factory and it’s hot when you turn the key on. I didn’t like how it was set up though so I took it off and put two separate bars back there for positive and ground that have I think 6 screws each. My speaker bar goes directly to the battery so I can use it when the machine is off. Other than the winch power wires though, everything else goes to the bus bar. Kawi made it super easy to hook things up. That center panel is only held in by like 6 pins and 2 screws. I had to pull the whole center tunnel out to run a few things as well. That requires a bit more work.
That's what i was looking for! thanks. Gonna have most of it torn down anyways for everything i got.
 
1 - 12 of 12 Posts
Top