Kawasaki KRX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
184 Posts
Discussion Starter #1 (Edited)
Title of subject sums it up.

I used 2" wide black sand texture finish in these areas. When cutting, always radius each corner as a sharp point of tape will start to lift and peel.

Put non-skid tape (like skateboard deck tape) on the accelerator and on the lower door threshold plate for shoe/boot scuff / slip protection.


looks sharp, and super functional dirt cheap DIY.
 

·
Registered
2020 Green KRX
Joined
·
245 Posts
Title of subject sums it up.

I used 2" wide black sand texture finish in these areas. When cutting, always radius each corner as a sharp point of tape will start to lift and peel.

Put non-skid tape (like skateboard deck tape) on the accelerator and on the lower door threshold plate for shoe/boot scuff / slip protection.


looks sharp, and super functional dirt cheap DIY.
Any pics you can share?
 

·
Registered
Joined
·
98 Posts
Rust-Oleum and Dura Grip both make commercial grade no-slip epoxy paint. It's pretty cheap and comes in all colors. Would stick to the pedals and wherever. Just another thought if the grip tape didn't end up working out.
 
1 - 4 of 4 Posts
Top