[SLVRBULLET40]

Replaced the kawasaki front bumper with the HMF front bumper. Says .095 steel tubing but don't know what brackets for my front kawasaki light bar. Any help would be appreciated

 

[Remote 8]

I looked at the install manual as I am looking to purchase a similar type of set up. You have the U4 model? I believe the tubing wall thickness is the .095 value. If you are looking for brackets to mount the bar, perhaps measure the OD of the tubing at the point where you are considering mounting light bar with a set of calipers and go from there? That's what I do FWIW. I am curious to hear how the install goes, and how the bumper works for you.

 

[SLVRBULLET40]

I looked at the install manual as I am looking to purchase a similar type of set up. You have the U4 model? I believe the tubing wall thickness is the .095 value. If you are looking for brackets to mount the bar, perhaps measure the OD of the tubing at the point where you are considering mounting light bar with a set of calipers and go from there? That's what I do FWIW. I am curious to hear how the install goes, and how the bumper works for you.

This is the bumper that's supposed to be here today by FedEx. But they always like to push the delivery date back. I've decided to remove that light. Still have my kawasaki roof light. I may go with cube lights later. It is .095 tubing so a universal clamp would have to be used if I kept the light.

 

[Remote 8]

Looks sharp, that's for sure. Doesn't look easy to mount a light on tho. I'm seeing 5-7 weeks out on these on vendor sites.

 

[SLVRBULLET40]

I ordered the bumper April 6th and got the notice it was shipped last Tuesday. I knew it was 5-6 weeks out but just had to be patient because this was the one I wanted for my AXON winch. Just don't want the winch sitting low.

 

[Mike Davis1107]

Good looking bumper actually looks more sturdy then OEM.