Kawasaki KRX Forum banner
1 - 10 of 10 Posts

·
Registered
2020 krx 1000. 35" System 3 xtr370's.
Joined
·
48 Posts
Discussion Starter · #1 ·
New member here. Just installed aftermarket clutch weights (rcor). Does anyone feel like they're just not as snug and do you feel that might not be a good thing. I tried to pinch them a bit with pliers just to be safe ,but didn't want to be to rough with them. Thoughts?
 

·
Registered
Joined
·
147 Posts
I had the same feeling when I installed my RCOR weights. Some "felt" better than others. I'm thinking about ordering replacements and putting them in next time I pull the cover for cleaning.

Sent from my SM-G991U using Tapatalk
 

·
Premium Member
2020 KRX
Joined
·
1,357 Posts
The main thing when removing those clips is to have the proper tool to do so, and go easy removing them. You only need to slightly open them enough to slide them off the pin. If they’re not snug when you reinstall them, do not run until you get replacements. Catastrophic clutch failure can happen if I pin comes out.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top