I’m at 59 miles in, still working on break in. I am hearing a different noise at 6000 rpm. Most of the time I am under this rpm since I Am still in the break in period. It should like a louder spinning noise coming from the engine. Thoughts? I’m going to pull the belt cover off tomorrow.
Break in noise.
Join the discussion
Recommended Reading
-
rolling backwards
2020+ Kawasaki KRX General Discussion Forumis it ok to roll backwards while in drive? like trying to get up a hill but failing and rolling back to the flat. See it all the time on other makes but thought I heard you "can't" or shouldn't or it's really bad for the krx? Any truth to this?- 0
- 16
-
Click noise in high gear when slowing down on a hill
2020+ Kawasaki KRX General Discussion ForumI have 80 miles on my Krx 1000 and was wondering if anyone else has had the click noise like something disengaging when going down a long smooth hill (+/- 25 degrees). After topping the hill and decelerating coming down it will use the engine brake for a couple of seconds then something...- 1
- 56
-
Salty199 · updated
-
Rear light locations.
2020+ Kawasaki KRX General Discussion ForumNeed ideas for rear light locations. The kaw spare tire holder blocks under the roof.- 2
- 175
-
Jumped out of gear on the road
2020+ Kawasaki KRX General Discussion ForumOn my first run out on the krx when rolling down a flat gravel road in high about 50mph backed off a bit for a turn and it kicked what seemed like in-between gears... rolled to a stop and shifter was in the high gate.. shut down and looked couldn't find anything wrong... pulled clutch cover...- 19
- 873
-
Fender flares
2020+ Kawasaki KRX General Discussion ForumAny one have a review or feed back on the factory fender flares? Or does anyone know of a aftermarket source even mud flaps would be nice.- 19
- 3K
Join now to ask and comment!